![]() The Hotspot mode will allow you to connect to your Wireless network without the need for a wired connection, just connect to Volumio Hotspot and configure your network in the Network options page.If your device has wireless capabilities (and a supported Wireless card) Volumio will create a Wireless network called Volumio, the default password is volumio2.IMPORTANT Do not configure your network manually via SSH, this can lead to issues and malfunctions.To do so, go to Settings -> Network and connect it from there If no ethernet is available, you can connect to its Hotspot (see below) and connect to your Wireless network.To connect Volumio to your network, simply attach an ethernet cable to it before starting it up.Volumio works best when it is connected to your network, since it is meant to be used as a headless device: no monitor connected, and controlled via another device (PC, smartphone, tablet etc).Generate new thumbnails for the default backgroundsįor security reasons, SSH is disabled by default on all versions after 2.199.Install some packages and configure the system.Regenerate SSH keys, to make them unique to your device.Extend the filesystem so it completely fills your SD Card / Hard drive.The first boot takes longer because it is performing these setup steps: Therefore, be patient on the first boot and wait about 5 minutes before starting to use Volumio. Volumio's first boot will take usually longer than normal, up to 6 minutes if you're on a Raspberry PI 1. Please have look here to download a version for your device and instructions to flash it : DOWNLOAD AND FLASH.Quick Start Guide Quick start guide DOWNLOAD AND INSTALLATION Creating the image build scripts (Part 2).Creating the image build scripts (Part 1).Set up development environment for Volumio images.Set up development environment for backend.Set up development environment introduction.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |